<![CDATA[RS-485 Multi-Drop Bus Reflection and Biasing Issues in Smart Meter Substation Loops]]>Substation Case Study: 64-Meter RS-485 Daisy Chain Failures

During commissioning of an industrial metering gateway polling 64 DLMS meters over an 800-meter RS-485 bus, we observed intermittent framing errors (CRC-16 HCS/FCS mismatch) when polling meters located beyond meter #40.

Oscilloscope Measurements

  • Differential Voltage ($V_A - V_B$): Ringing amplitudes exceeded 1.8V during signal transitions.
  • Idle Bus State: Floating between -50mV and +80mV, falling into the RS-485 receiver indeterminate zone (-200mV to +200mV).

Corrective Engineering Measures

  1. 120-Ohm Termination Resistors: Installed strictly at the physical two extreme ends of the daisy chain (Gateway and Meter #64). Removed intermediate termination switches from middle meters.
  2. Fail-Safe Biasing: Added 680-ohm pull-up on Line A (+5V) and 680-ohm pull-down on Line B (GND) at the gateway master to hold idle voltage at $+250\text{ mV}$.
  3. Baud Rate Optimization: Standardized at 9600 bps, 8N1 with shielded twisted pair (STP, 24 AWG, $120,\Omega$ characteristic impedance).

Result: 100% packet success rate across all 64 nodes over continuous 72-hour run.

]]>https://dlms.sharur.org/topic/32/rs-485-multi-drop-bus-reflection-and-biasing-issues-in-smart-meter-substation-loopsRSS for NodeFri, 16 Oct 2026 19:48:57 GMTSat, 22 Aug 2026 12:36:18 GMT60<![CDATA[Reply to RS-485 Multi-Drop Bus Reflection and Biasing Issues in Smart Meter Substation Loops on Sat, 22 Aug 2026 12:36:27 GMT]]>Proper biasing is essential! Without fail-safe bias resistors, when the transmitter driver enters high-impedance tri-state mode between frames, ambient electrical noise triggers spurious start bits on UART controllers, generating Invalid Opening Flag errors.

]]>https://dlms.sharur.org/post/75https://dlms.sharur.org/post/75Sat, 22 Aug 2026 12:36:27 GMT